电气工程论文网


  • 首页|
  • 自动化毕业论文|
  • 电子机电毕业论文|
  • 电子通信论文|
  • 电气工程论文|
  • 电子信息工程|
  • 电气工程原创论文|
  • 电气工程免费论文|
原创毕业论文 → 电气工程专业原创毕业论文   现成毕业论文范文 → 电气工程专业毕业论文范文

论文降重

当前位置:电气工程论文网 -> 电子通信论文 -> MAX2754芯片简介及应用电路设计

MAX2754芯片简介及应用电路设计

本文ID:LW1019 字数:4470,页数:15
MAX2754芯片简介及应用电路设计

字数:4470,页数:15


摘要 
MAX2754为单片、带线性调制输入的压控振荡器(VCO),适用于2.4GHz至2.5GHz ISM频段,尤其适合直接采用频率调制发送结构的FSK调制系统。这个芯片除了标准的频率调整输入外还可以接收线性调制输入。频率调整范围从1145MHz至1250MHz (1/2 LO),可支持输入频率高达110MHz。VCO是基于Maxim专有的单片集成VCO技术,所有的VCO单元集中在一块芯片上,包括变容二极管和电感器。
MAX2754线性调制输入提供了一种在调谐输入电压范围内以固定的调制灵敏度直接对VCO调频的方法。在保证的频率范围内,典型的频率偏差是-500kHz ,线性度为±4%。输入电压的调整范围是+0.4V至+2.4V,振荡器的频率由工厂预置,确保频率限制范围。振荡器信号经过输出放大器(内部匹配到50)缓冲,以提供高输出能力、并且使振荡器与负载阻抗变化相隔离。
MAX2754的工作电压为+2.7V至+5.5V。该芯片提供一种数控关断模式,可实现灵活的电源管理。关闭后,电源电流减小到0.2μA。工作模式下能量消耗也只有41mW。
MAX2754采用8引脚μMAX 封装,是尺寸最小、最完备的2.4GHz直接调制VCO解决方案。
Abstrac
The MAX2754 self-contained, linear modulation, voltage-controlled oscillator (VCO) is intended for use in the 2.4GHz to 2.5GHz ISM band, particularly for FSK modulation systems that utilize a direct frequency-modulation transmit architecture. This device features a linear modulation input in addition to the standard frequency tuning input. The frequency tuning range of 1145MHz to 1250MHz (1/2 LO) also supports an IF up to 110MHz with low side LO. The VCO is based on Maxim’s proprietary monolithic VCO technology, where all VCO components are integrated on-chip, including the varactor and inductor.
The MAX2754 linear modulation input offers a means to directly FM modulate the VCO with a constant modulation sensitivity over the tuning voltage input range. Typical frequency deviation is -500kHz  which is linear to ±4% over the guaranteed frequency limits. The tuning input voltage range is +0.4V to +2.4V and the oscillator frequency is factory adjusted to provide guaranteed limits. The oscillator signal is buffered by an output amplifier stage (internally matched to 50Ω) to provide higher output power and isolate the oscillator from load impedance variations.
The MAX2754 operates over a +2.7V to +5.5V supply range. This device also provides a digitally controlled shutdown mode to permit implementation of sophisticated power-supply management. In shutdown, the supply current is reduced to 0.2μA. Even when active, power consumption is a modest 41mW. The MAX2754 is packaged in the miniature 8-pin μMAX to offer the world’s smallest, complete 2.4GHz directmodulation VCO solution.

 

关键字:       MAX2754      压控振荡器       线性调制         特性曲线    
    调频偏差
Key  words: MAX2754      VCO    Linear Modulation  Characteristic      Frequency-modulation deviation

目录
1  芯片介绍 ...................................................................(4)
1.1  芯片特点..................................................................(4)
1.2  引脚配置 .................................................................(5)
1.3  工作电路图................................................................(5)
1.4  芯片规范参数 .............................................................(6)
2  电路的各种特性 .............................................................(6)
2.1  直流特性 .................................................................(6)
2.2  交流特性 .................................................................(7)
2.3  交流特性(延续)..........................................................(7)
2.4  典型工作特性..............................................................(8)
3  应用电路说明 ...............................................................(10)
3.1  管脚描叙..................................................................(10)
3.2  详细说明..................................................................(11)
3.3  线性调制..................................................................(11)
3.4  输出缓冲器................................................................(11)
3.5  应用资料..................................................................(11)
3.6  系统测试..................................................................(13)
4   芯片包装 ..................................................................(13)
  4.1  包装资料 ...............................................................(13)
5   结论 ......................................................................(14)
6   参考文献 ..................................................................(15)

下载地址 WORD格式全文下载链接(充值:30元)


MAX2754芯片简介及应用电路设计......
论文人工降重
本论文《MAX2754芯片简介及应用电路设计》在电子通信论文栏目,由电气工程论文网整理,转载请注明来源 www.dqlunwen.top 更多论文,请点电气工程论文查看
上一篇:MPC92432芯片简介及应用电路设计 下一篇:LMX2310U/LMX2311U/LMX2312U/LMX2..

点击查看关于 MAX2754芯片 简介 应用电路 设计 的相关论文题目 2009-06-09 16:16:08【返回顶部】
联系方式

相关栏目

光机电应用技术
机电一体化
应用电子技术
电子信息工程技术
自动化免费论文
自动化专业毕业论文
电子专业免费论文
电子机电毕业论文
电气工程免费论文
测控技术与仪器
电气工程原创论文
电子通信论文
电气自动化开题
电子机电开题报告
电子通信免费论文
PLC相关外文翻译
电子机电信息外文翻译
电子通信外文翻译
联系方式
电子信息工程论文下载
电气工程论文下载


联系方式


电气工程论文网提供电气工程论文范文,电气工程毕业论文,网站永久域名www.dqlunwen.top 

本站部分文章来自网友投稿上传,如发现侵犯了您的版权,请联系指出,本站及时确认并删除  E-mail: 17304545@qq.com

Copyright@ 2009-2022 电气工程论文网 版权所有