电气工程论文网


  • 首页|
  • 自动化毕业论文|
  • 电子机电毕业论文|
  • 电子通信论文|
  • 电气工程论文|
  • 电子信息工程|
  • 电气工程原创论文|
  • 电气工程免费论文|
原创毕业论文 → 电气工程专业原创毕业论文   现成毕业论文范文 → 电气工程专业毕业论文范文

论文降重

当前位置:电气工程论文网 -> 自动化专业毕业论文 -> 330KV变电站保护配置设计

330KV变电站保护配置设计

本文ID:LW9640 字数:9382,页数:27
330KV变电站保护配置设计

论文编号:ZD783    论文字数:9382,页数:27

摘要
 随着我国电力工业的迅速发展,各大电力系统的容量和电网区域不断扩大。继电保护装置广泛应用于电力系统、农网和小型发电系统,是电网及电气设备安全可靠运行的保证。
 在发电厂和变电所的各级电压配电装置中,大都采用矩形或圆形截面的裸导线或绞线,这将发动机、变压器与各种电器连接的导线,统称为母线;母线的作用是汇集、分配和传送电能。由于母线在运行中,有巨大的电能通过,短路时,承受着很大的发热和电动力效应,因此,必须合理的选用母线材料、截面形状和截面积以符合安全经济运行的要求。
 本设计根据典型的330kV发电厂和变电所电气主接线图、方法,根据厂、所继电保护、静补装置、站用变压器及双母线的要求,设计保护330KV变电站的措施及方法。
 
关键词: 双母线 330KV变电站 静补装置 变电站保护


Abstract
 With the rapid development of China's power industry, the major power system capacity and expanding the regional power grid. Protection devices are widely used in power systems, Rural and small power systems, power grid and electrical equipment is safe and reliable operation of the guarantee.
 Levels in power plants and substations voltage power distribution equipment, mostly rectangular or circular cross-section of bare wire or stranded wire, which will motors, transformers and various electrical wires connected to, distribution and transmission of electricity. As the bus running, there is tremendous power through, short circuit, under a lot of heat and electric power effect, therefore, must be reasonable selection of bus material, section shape and area to meet the safety requirements of economic operation.
 The design according to the typical 330kV power plants and substations electrical wiring diagram of the main methods, according to plant, the relay, static fill device, double busbar substation transformer and the requirements of the measures designed to protect 330KV substation and methods.
Key words: double bus substation 330KV substation protection devices Static Compensation

摘要 2
1、 绪论 5
2、 发展现状 6
2.1电力系统电压等级与变电站种类 6
2.2 变配电站种类 7
2.3 变电站的保护方法 7
2.3.1继电保护 7
2.3.2 变电站继电保护按被保护对象分类 9
3、 建立保护方案 11
3.1 双母线 11
3.1.1 双母线分类 11
3.1.2 双母线的优缺点 12
3.1.3  330kV母线接线方式 12
3.2静补装置 13
3.2.1 定义 13
3.2.2 静补装置用在电力系统 13
3.2.3 使用静补装置考虑条件 14
3.2.4 静补装置原理 14
3.3系统继电保护及安全自动装置 15
3.3.1系统继电保护及自动装置 15
3.3.2继电保护配置原则 16
3.3.3 330KV系统 16
3.3.4  110千伏系统 17
3.4 绝缘配合及过电压保护 17
3.4.1在330KV超高压系统中 17
3.4.2防直击雷保护 18
3.4.3接地 18
4、330KV变电站保护设计 18
4.1 变电站的电气主接线 18
4.1.1 330kV主接线: 19
4.1.2 110千伏主接线 20
4.1.3 35千伏接线 20
4.2 变电站保护 20
4.3继电保护装置配置 21
4.3.1  330kv甲站 21
4)短引线保护可以单配。(共配4套) 22
4.3.2  330kv乙站 22
4.4、装置选型及技术条件 22
4.4.1、330kv线路保护 22
4.4.2后备保护配置 23
4.5屏柜统计表 24
5、总结 24
参考文献 26

下载地址 WORD格式全文下载链接(充值:50元)


330KV变电站保护配置设计......
论文人工降重
本论文《330KV变电站保护配置设计》在自动化专业毕业论文栏目,由电气工程论文网整理,转载请注明来源 www.dqlunwen.top 更多论文,请点电气工程论文查看
上一篇:AT89S52单片机在印刷检测上的应用 下一篇:110kv变电站设计

点击查看关于 330KV 变电站 保护 配置 设计 的相关论文题目 2010-08-21 11:34:36【返回顶部】
联系方式

相关栏目

光机电应用技术
机电一体化
应用电子技术
电子信息工程技术
自动化免费论文
自动化专业毕业论文
电子专业免费论文
电子机电毕业论文
电气工程免费论文
测控技术与仪器
电气工程原创论文
电子通信论文
电气自动化开题
电子机电开题报告
电子通信免费论文
PLC相关外文翻译
电子机电信息外文翻译
电子通信外文翻译
联系方式
电子信息工程论文下载
电气工程论文下载


联系方式


电气工程论文网提供电气工程论文范文,电气工程毕业论文,网站永久域名www.dqlunwen.top 

本站部分文章来自网友投稿上传,如发现侵犯了您的版权,请联系指出,本站及时确认并删除  E-mail: 17304545@qq.com

Copyright@ 2009-2022 电气工程论文网 版权所有